Drill Press Table

Posted on
Drill Press Table

This is a drill press table I made out of some left over melamine.  The dimensions are 15″ x 18″ x 1 1/2 “.  I cut two pieces of the melamine and added hinges  on the back ,  so that I could conceal the mounting hardware.  I also cut a 5″x 5” square out of the center for thru cuts with the drill bits.  The T-tracks where added for the adjustable  fence and hold down hardware as well as stop blocks for exact repeat cuts.  The tracks will also increase safety when used with hold down clamps.

Leave a Reply

Your email address will not be published.